EMG Pickups Accessories

EMG-AB Afterburner
The AB (Afterburner) is a push/pull booster with up to 20dB of preset variable gain, perfect for having fun with clean overdrive and distortion. It works with both active and passive pickups, uses rail-to-rail technology, and is easy to install. If you're a lead player, the Afterburner is for you.

Package Includes: Output jack and battery clip set.

EMG-SPC
The SPC or "Strat Presence Control" is often called the fat control. The original intent of the SPC was to turn the tone of a single-coil pickup into a dual-coil. This is accomplished by boosting the gain in a broad mid-band fashion and reducing the highs. The result is a fatter, louder tone from any single coil pickup, but you can also use it on a humbucking to give you a high output, really fat tone that's great for slide guitar.

EMG-RPC Resonat Peak Control
The RPC is a variable active control that boosts the high frequency response up to 6 dB at 4000 Hz, while simultaneously reducing low frequency response. Its potentiometer controlled circuitry allows you to sweep from natural sound to accentuated highs typical of single-coil pickups. Like the EMG-SPC, it can be wired to one pickup or at the output of the guitar.

EMG-EXG Guitar Expander
For flexibility in tone at your fingertips there is no better choice than the EXG Guitar Expander. The frequency response of the EXG is similar to normal guitar amp equalization. The lows and highs are boosted while the midrange is dipped out. The EXG is great for creating a fuller tone that doesn't get muddy, while keeping it clean and clear, letting your guitar stand out in the mix.

EMG-Pi2 Phase Inverter
The Pi2 is an active phase reversal circuit mounted on a mini-toggle switch, and is used in guitars with two or more EMG Pickups. Wired in series with one of the pickups, The Pi2 produces true "out of phase" sound by reversing the phase of the pickup. The active method of phase reversing is superior because it maintains the quietness of an EMG equipped instrument. It requires the same amount of space as a conventional phase switch, and only four solder connections are necessary. Along with the Pi2, mounting hardware and complete instructions are included to make installation easy.

EMG-PA2
The PA2 is a straight booster preamplifier mounted on a minitoggle switch. Perfect if you want to just plain overdrive the input of your amp for distortion. It has a trim pot so you can preset the amount of boost up to an additional 20 dB. The PA2 will also work with passive pickups.

Package Includes: Output jack and battery clip set.

EMG-EXB Bass Expander
The EMG-EXB is an unconventional equalization control for bass that increases the low and high frequency regions while reducing the midrange simultaneously to provide the gain and punch that bass players want. Slap players will especially appreciate its superior clarity and percussive quality. Similar in design and construction to the EMG-EXG, this unit is compact and will fit into most EMG equipped instrument control compartments without any modification. Instruction and wiring diagrams are included for easy installation.

Package Includes: Output jack and battery clip set.

EMG-VMC Variable Mid Control
The VMC (Variable-Mid-Control) is perfect for dialing in just the tone you want. Using the cut to reduce the mids gives you that classic full bottom end with a snappy high end. By boosting the mids you can get a fat and boomy low end.

Package Includes: Output jack, battery clip set, and knobs.

B-30EQ
The B30 equalizer was designed for contouring bass, mid and treble frequencies of bass guitar. It features single-pole filters for broadband equalization of 6db per octave. Often the broader single-pole filters are preferred for musical instruments because they are less selective, easier on the ear and sound more “musical”. The B30EQ has a center detent for easy reset to “flat” response, has a high input impedance, and can be used with active or passive pickups. Bass, Mid and Treble controls are spaced 1.25 inches (31.75mm) on center. Split Shaft pots are used throughout.

B-64EQ
The B64 Equalizer was designed for contouring bass, mid and treble frequencies of bass guitar. Unlike the B30EQ, it has a tighter filter bandwidth giving a more pronounced effect from each control. The mid-cut of the B64 is perfect for “funk” with its mid-range centered at a lower frequency. Both Bass and Treble controls on the B64 are more selective and don’t creep into the mid-range as much as the B30. This control also has center detent for easy reset to “flat” response, a high input impedance, and it can be used with active or passive pickups. Bass, Mid and Treble controls are spaced 1.25 inches (31.75mm) on center. Split Shaft pots are used throughout.

EMG-BTC Control
The BTC Control features a bass and treble equalizer on a concentric (stacked) pot. It takes up very little space and will work with any pickup, active or passive. It comes complete with knobs (including 2 extra volume knobs). BTC Controls and Systems are the most widely used bass EQ Systems in the world. Approximately 12db of cut and boost are available for bass and treble and all controls are center detented to assure quick return to normal tone settings. A dual-dip switch is mounted to the PC Board that lets you program the high end frequency response four different ways so you can choose the sound that's right for you. These systems use the latest in surface mount technology, are extremely quiet, and require very little current from a 9 Volt battery.

Package Includes: 2 concentric knobs, 2 control knobs, output jack, and battery clip set.

BTC System
For EMG pickups only, the BTC System features a pre-wired balance control (blend) and master volume with the bass and treble on a concentric pot. BTC Controls and Systems are the most widely used bass EQ Systems in the world. Approximately 12db of cut and boost are available for bass and treble and all controls are center detented to assure quick return to normal tone settings. A dual-dip switch is mounted to the PC Board that lets you program the high end frequency response four different ways so you can choose the sound that's right for you. These systems use the latest in surface mount technology, are extremely quiet, and require very little current from a 9 Volt battery.

Package Includes: 2 concentric knobs and 2 knobs for balance/master volume.

EMG-BTS Control
The BTS Control is essentially the same as the BTC Control but instead of a concentric pot, the controls are separate. The BTS Control will also work with active or passive pickups. Both pots are center detented, and 4 knobs are included.

Package Includes: 2 control knobs, 2 extra knobs, output jack, and battery clip set.

BTS System
For EMG pickups only, the BTS System features a pre-wired balance control (blend) and master volume with the bass and treble on separate pots.

Package Includes: 4 control knobs.

EMG-BQC Control
The BQC Control features a bass and treble equalizer on a concentric (stacked) pot along with the concentric (stacked) mid-control. It takes up very little space and will work with any pickup, active or passive. It comes complete with knobs including 2 extra volume knobs.

Package Includes: 2 concentric knobs sets, 2 extra knobs, output jack, and battery clip set.

BQC System
For EMG pickups only, the BQC System features a pre-wired balance control (blend) and master volume with both the bass and treble on a concentric pot as well as the mid-control. All the EQ controls and balance control feature center detents.

Package Includes: All knobs included.

EMG-BQS Control
The BQS Control is essentially the same as the BQC Control but the bass and treble controls are separate. The mid-control is concentric (stacked). The BQS Control will also work with active or passive pickups. The pots are center detented, and 2 extra volume knobs are included.

Package Includes: All knobs included and 2 extra control knobs for additional uses.

BQS System
For EMG pickups only, this system features a pre-wired balance control (blend) and master volume with separate bass and treble pots along with the concentric mid-control (stacked). All the EQ controls and balance control feature center detents.

Package Includes: All knobs included.

Please Note. Most items are order on request only. If the Item is in U.K stock delivery takes between 5 to 10 days.
Out of stock items will be notified by e-mail with the next expected deliver time.
You can add,change or deleat you order at any time provided it has not been dispatched.