Exotic wiring combinations, Ultimate control!
4 Pole 24 Terminal Super Switch
As used with the Amrican Standards Fender™
Each pole has six lugs (one common lug, and one for each for the five lever positions). This lets you wire guitars in imaginative ways not possible with other 5-way switches.
The Super Switch requires 1-7/16" (36mm) body cavity depth,and is 14/16"(22mm) wide This product will fit into the normal Fender™ 5 way switch slot in the pickguard or control plate provided there is enough space to accomodate it..
Mounting screws and both black and white switch knobs are included.

This switch allows a level of flexibility and control that is not possible with traditional lever switches. The diagam below is designed to give you an understanding of how the switch works More detailed wiring instructions can be found by searching the internet or you can develop your own custom ideas and set-ups. Coil cuts, series/parallel combinations, phase reversal and more can all be done.

Terminal assignment
There are a total of 24 solder terminals (lugs) on this switch. The switch is divided into four separate circuits, or poles, and each pole has six lugs. Lug “0” is the “common” which is connected to other lugs depending on the lever’s position. The five other terminals on each pole correspond to the five positions of the switch. Lug #1 = position 1, Lug #2 = position 2, etc.

Many lever switches use the commons as outputs for the switch, but with this switch this is not necessarily going to be the case. The commons of this switch can be used to connect pickups together in ways not possible with other switches. This is an important concept to understand when designing custom wiring for this switch.

Soldering tips
When soldering to the switch, be careful not to overheat the terminal lugs. This could damage the switch, or cause other intermittent problems. We recommend pre-tinning all connections prior to soldering–for improved contact and better solder joints. Be sure to use small diameter rosin-core solder (DO NOT USE ACID CORE SOLDER!) and a 25-45 watt soldering iron. Soldering guns are much too large for the small, delicate contacts of the components used in guitar electronics.

Designed for guitarists by Schaller in Germany, The Megaswitch features heavy-duty die-cast construction, noise-free contacts, and the best "feel" of all our lever-action switches.

P-Model Megaswitch is for two humbucking pickups. This 5-way lever-action switch duplicates the combinations of Paul Reed Smith's rotary control in to a standard Fender style 5 way switch

The P Megaswitch is recommended for the following pickup combinations:

5 way lever switch.
Positions:
1 Bridge pickup
2 Inner pickup coils, parallel
3 Outer coils, series
4 Outer coils, parallel
5 Neck pickup

The Original 'E' Model Megaswitch brings out the five best possible sounds from 3-pickup combinations of single-coils or humbuckers. It replaces a standard 5-way Strat®-style switch, for new wiring options plus coil-tapping, and lets the guitarist combine pickup coils for hum elimination.

The E Megaswitch is recommended for the following pickup combinations: